Studer’s uniLoad system is easy to operate that no special programming training is required. The control was developed by Wenger Automation. The user only needs to know the dimension and weight of the workpiece in order to use the loading system. The set-up wizard then guides the user conveniently through the necessary steps to start the grinding programme.

The Studer uniLoad is offered based on a linear portal cell with two parallel grippers and is suitable for shaft components up to a length of 350mm and a diameter of 100mm. It thus covers a large proportion of the component ranges produced on these machines. The parts are supplied via a standardised, adjustable V-belt. The housing for the base module, which is provided with a loading hatch as standard, has been adapted to suit the machine design and enables safe and clean operation of the system.

Studer’s uniLoad is currently suitable for distances between centres of 650mm and 1 000mm. With the racks at full capacity, the loading system is docked onto the machine and enables automated processing of around one hour. In the case of workpieces with an external diameter of 34mm and a gripper diameter of 22mm, 50 parts can be loaded automatically. The look of the loading system is reflected in the aesthetic design of the machine, and as a standard product enables quick response and delivery times. Customised solutions are also possible. In addition, uniLoad is expandable so future requirements can also be met.

The uniLoad is equipped with a Siemens Simotion control, gripper with quick change jaws, and an intuitive 15-inch operating panel.

For more information contact Retecon on TEL: 011 976 8600 or visit www.retecon.co.za